- Easy installation
- Fits virtually every spa
- Mounts directly to the spa cabinet
- Corrosion resistant compression gas springs
- Sturdy 3.2 cm (1 ¼-in.) diameter Galvalume tubing with corrosion-resistant powder coating
The Hydraulic Mount hot tub cover lifter incorporates gas springs to assist with the opening and closing of your hot tub. The gas springs offset the weight of the cover, increasing your enjoyment and safety when using your hot tub or spa. It also makes it easier to place your cover securely and in the correct position when closing, which will reduce heat loss from your tub.
- • Made in North America
- • Limited Lifetime Warranty
- • Aluminum Brackets
- • Galvanized Arms
- • Use on In-Ground Spas
- • Extensions Available
- • Max Cover Width: 109"
- • Max Corner Radius: 16"
- • Clearance Required: 12-14" & 5" on the Side
Customer ReviewsWrite a review
The instructions were very generic and pictures not helpful. The video instructions show only partial images of parts so you’re not really sure what parts are what.
Overall we installed it and it is fine, however it took way longer than it should have.
In addition, it was lopsided when we were done. Better instructions and measurements would have helped.
Hydraulics are not as good as they can/should be, otherwise good product. However, the install instructions are the worst I have ever seen (yes, worse than Ikea). Printed manual is photos taken from the video and never shows what end of pieces to use, and therefore since the printed is pulled from the video, the video is just as bad.