Features:
- Reliable center discharge performance
- 1 ½” intake and discharge
- Wet end can be rotated for easy installation
- Viton Seals
- 2 Speed
Orientation of wet end.
Pump wet end can be oriented in 90 Degree increments, up, left or right as shown in illustration on the right. Pump will ship with discharge directed up. To change the discharge orientation, loosen the pump's four through bolts from the back of the motor and pull them back enough to disengage. Then rotate the wet end to the desired position, realign and re-tighten the bolts.
Important
Determine the pump plumbing size by measuring the outside diameter of the wet end male threads. Plumbing sizes for hot tubs are nominal, and not actual outside diameter (O.D.) of the the threaded intake or discharge. Once you have removed the pump, use a tape measure to check your old pump thread size and compare to the sizes below.
If your pump thread O.D. is (approx.) 2 3/8", Then you'll need a pump with union size 1 1/2".
If your pump thread O.D. is (approx.) 3.0", Then you'll need a Pump with union size 2.0".
If your pump thread O.D. is (approx.) 3 5/8", Then you'll need a Pump with union size 2 1/2".
If your pump thread O.D. is (approx.) 3.0", Then you'll need a Pump with union size 2.0".
If your pump thread O.D. is (approx.) 3 5/8", Then you'll need a Pump with union size 2 1/2".
** Please note that these parts are Non-Refundable. If there is a product fault it will only be under Warranty if it is installed by a Professional, Self installation voids Warranty.